MOTO GUZZI BREVA V1100 Manual page 18

Should the heated handgrips be fitted
( ) and active, the display will show a
OPT
special icon, instead of the selected TRIP,
and the TRIP indication is given in the area
below. The icon identifies three levels of
heating.
MODE
MODE configuration features the functions
allowing the user to interact with the
system.
To enter the MODE function:
Set the selector (1) to MODE position.
u
Briefly press the SET (2) push-button to
display the following functions one after the
other:
√ LAP TIMER;
√ MENU (function disabled when vehicle is
in motion);
√ BATTERY VOLTAGE;
18
use and maintenance Breva
LAP TIMER
When the vehicle is on a track, the lap
timer allows the user to measure the lap
time and store data that can be later
retrieved.
To enter the LAP TIMER function:
Confirm selection on CHRONO by
u
pressing the SET (2) push-button for
several seconds.
The display will show the following options:
√ EXIT
√ TIMING
√ VIEW TIMES
√ DELETE TIMES;
Options can be selected in a sequence by
briefly pressing the SET(2) push-button.
To exit this function, confirm the EXIT
u
option by pressing the SET (2) push-
button for several seconds.
TIMING
To turn on the TIMING:
confirm selection on TIMING by pressing
u
the SET (2) push-button for several
seconds.
The display will show the actual value and
the previous three values stored. To the
left of the value is the lap number.
To start the timing:
Briefly press the SET (2) push-button.
u
If you press the SET push-button again
within the first 10 seconds from when the
timer starts recording, the lap timer will
reset.
After 10 seconds, if you push it again, the
data will be stored and the next lap timer
will start recording.
Press the SET (2) push-button for several
seconds to cancel the lap timer session.
The counter on the display is reset. Briefly
press the SET (2) push-button to restart
the session.