Tire; Rear Brake Lamp Switch; Tire Pressure - HYOSUNG GV 250 EFI Owner's Manual

●

Rear brake lamp switch

The rear brake lamp switch is located at
right-side of the engine.
Move the switch up or down to adjust it
until the switch operates and turns on the
brake lamp after the brake pedal begins to
be depressed.
Inspect the tire pressure and the tire
thread depth periodically.
Inspect frequently the tire pressure for the
safety and the tire life.
WARNING
Failure to follow these warnings may
result in an accident due to tire failure.
The tires on your motorcycle form the
crucial link between your motorcycle
and the road.
Follow these instructions ;
● ● Check tire condition and pressure,
and adjust pressure before each ride.
● ● Avoid overloading your motorcycle.
● ● Replace a tire when worn to the
specified limit, or if you find damage
such as cuts or cracks.
● ● Always use the size and type of tires
specified in this owner's manual.
◉ ◉ TIRE PRESSURE
Insufficient air pressure in the tires not
only hasten tire wear but also seriously
affects the stability of the motorcycle.
Under-inflated tires make smooth
cornering difficult and over-inflated tires
decrease the amount of tire in contact with
the ground which can lead to skids and loss
of control. Be sure that the tire pressure is
within the specified limits at all times.
Tire pressure should only be adjusted
when the tire is cold.
If you see the problem with the tire, adjust
the pressure with the pressure gauge.
54

TIRE