Cleaning Procedure; Washing - HYOSUNG GV 250 EFI Owner's Manual

CLEANING PROCEDURE

A thorough cleaning of your motorcycle is
a necessary part of maintenance and will
help keep your motorcycle looking and
performing its best. Proper cleaning can
also extend the life of your motorcycle.
It is important to clean and inspect your
motorcycle after every ride if it is used in
mud, brush, grass, water, salt water, or very
dusty conditions.
The build-up of mud, brush, grass, etc,
especially on the engine and exhaust
system, can reduce engine cooling, conceal
damage, or increase wear of certain parts. It
is important to remove all debris during
cleaning.
CAUTION
High pressure washers can damage
your motorcycle (especially the oil
cooler pin).
High pressure washers such as those
found at coin-operated car washes have
enough pressure to damage the parts of
your motorcycle. It may cause rust,
corrosion and increase wear.
Do not use high pressure washers to
clean your motorcycle.
◉ ◉ WASHING YOUR motorcycle
With some care, your motorcycle can be
washed in a similar manner to washing an
automobile.
N O T E
Avoid spraying or allowing water to flow
over the following places :
● ● Ignition switch
● ● Fuel injection system
● ● Brake master cylinders
● ● Oil cooler fins
● ● Snorkel air intake for air cleaner
● ● Spark plug
● ● Fuel tank cap
CAUTION
Do not use parts cleaner to throttle body
and fuel injection sensors.
63