Air Cleaner; Battery Installation - HYOSUNG GV 250 EFI Owner's Manual

◉ ◉ BATTERY INSTALLATION
's battery installation order
pay attention to following points :
( ─ ) Lead wire
⇒ Front side
1. Remove the front seat, right frame cover
and battery support.
2. Lay down (＋) positive terminal of the
battery at leftside of the battery case (on
the motorcycle).
3. Connect (＋) positive battery wire at the
battery terminal.
4. Put on the rubber cap at the (＋) positive
terminal of the battery.
5. Install ( ─ ) negative battery wire at the
battery terminal.
6. Install the battery support, right frame
cover and front seat.
CAUTION
If connect first the battery wire at
the battery then lay down at the
battery case, will be installed the
opposite direction [( + ) positive
terminal face on the rightside of the
motorcycle] as that length of the ( + )
battery wire has no something
extra.
This time, the battery could not lay
down perfectly and to occur the
short circuit etc. if the battery
install the opposite direction.

AIR CLEANER

If the air cleaner element has become
clogged with dust, intake resistance will
increase with a resultant decrease in power
output and an increase in fuel consumption.
If riding under severe conditions must be
cleaned or replaced more frequently than
maintenance schedule. Check and clean
the air cleaner element periodically
according to the following procedure.
CAUTION
If the air cleaner element is polluted, will
occur to starting go out, output
insuffiency, combustion effiency
decline, and sooty smoke (black
smoke).
This appearence is occurred at first to
clean the air cleaner element and
confirm.
1. Remove the screws ①
cover ② .
43
and remove the
�
�