Appendix A: Integration And Usage Tips - Intel SR1530CLR - Server System - 0 MB RAM Technical Specification, Installation And Operation Manual

Server systems

Hide thumbs Also See for SR1530CLR - Server System - 0 MB RAM:

Table of Contents

Intel® Server Systems SR1530CL/SR1530HCL/SR1530HCS

and SR1530CLR/SR1530HCLR/SR1530HCLSR

Appendix A: Integration and Usage Tips

This section provides a list of useful information that is unique to the Intel

SR1530CL/SR1530HCL/SR1530HCLS and should be kept in mind while integrating and server

system.

Only low-profile (1.2 inch or 30.48 mm) FBDIMMs can be used in the server systems.

Processor fans are not needed and are not supported. The system fan blowers and

power supply fans provide the necessary cooling needed for the system. Using a

processor fan in these systems may cause Intel

incorrectly monitor the system fans.

The air duct must be used to maintain system thermals.

System fan blowers are not hot swappable

A screw on the front edge of the top cover is required when the unit is installed in a user-

accessible environment.

The FRUSDR utility must be run to load the proper sensor data records for the server

system onto the server board.

Make sure the latest system software is loaded. This includes system BIOS, FRUSDR,

and BMC firmware. The latest system software can be downloaded from

http://support.intel.com/support/motherboards/server/S5000VCL/

Revision 2.2

System Management Software to

Intel order number D71005-005

Appendix A: Integration and Usage Tips

Server Systems

Table of Contents

Do you have a question about the SR1530CLR - Server System - 0 MB RAM and is the answer not in the manual?