Dodge 2008 Dakota Owner's Manual page 17

seconds, but no longer than 15-seconds. Then, turn the
ignition switch to the "LOCK" position and remove the
first key.
3. Insert the second valid key into the ignition switch.
Turn the ignition switch to the "ON" position within 15
seconds. After ten seconds, a chime will sound. In
addition, the Vehicle Security Alarm Indicator Light will
begin to flash. Turn the ignition switch to the "LOCK"
position and remove the second key.
4. Insert a blank Sentry Key into the ignition switch. Turn
the ignition switch to the "ON" position within 60
seconds. After 10 seconds, a single chime will sound. In
addition, the Vehicle Security Alarm Indicator Light will
stop flashing. To indicate that programming is complete,
the indicator light will turn on again for 3 seconds and
then turn off.
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 17
The new Sentry Key is programmed. The Keyless Entry
Transmitter will also be programmed during this pro-
cedure.
Repeat this procedure to program up to 8 keys. If you do
not have a programmed sentry key, contact your dealer
for details.
NOTE: If a programmed key is lost, see your dealer to
have all remaining keys erased from the systems
memory. This will prevent the lost key from starting your
vehicle. The remaining keys must then be repro-
grammed. All vehicle keys must be taken to the dealer at
the time of service to be reprogrammed.
2