Populating Sodimm Sockets - HP SignagePlayer mp8200 Hardware Reference Manual

Populating SODIMM Sockets

There are two SODIMM sockets on the system board, with one socket per channel. The sockets are
labeled XMM1 and XMM3. The XMM1 socket operates in memory channel A. The XMM3 socket
operates in memory channel B.
Figure 2-9
Table 2-1
Item Description
1 SODIMM1 socket, Channel B
2 SODIMM3 socket, Channel A
The system will automatically operate in single channel mode, dual channel mode, or flex mode,
depending on how the SODIMMs are installed.
The system will operate in single channel mode if the SODIMM sockets are populated in one
●
channel only.
The system will operate in a higher-performing dual channel mode if the memory capacity of the
●
SODIMM in Channel A is equal to the memory capacity of the SODIMM in Channel B.
The system will operate in flex mode if the memory capacity of the SODIMM in Channel A is not
●
equal to the memory capacity of the SODIMM in Channel B. In flex mode, the channel populated
with the least amount of memory describes the total amount of memory assigned to dual channel
and the remainder is assigned to single channel. If one channel will have more memory than the
other, the larger amount should be assigned to channel A.
In any mode, the maximum operational speed is determined by the slowest SODIMM in the
●
system.
18 Chapter 2 Hardware Upgrades
SODIMM Socket Locations
SODIMM Socket Locations
System Board Label
XMM1
XMM3
Socket Color
Black
Black