Configuring Controller Information; Clearing Manually Entered Controller Information; Manually Resetting The Access Point To Defaults; Mode Button Setting - Cisco AIR-AP1252AG-A-K9 Hardware Installation Manual

Chapter 4 Troubleshooting 1250 Series Lightweight Access Points

Configuring Controller Information

To manually configure controller information on a new (out-of -the-box) access point using the access
point CLI interface, you can use these EXEC mode CLI commands:
AP# lwapp ap ip address <IP address> <subnet mask>
AP# lwapp ip default-gateway IP-address
AP# lwapp controller ip address IP-address
AP# lwapp ap hostname name
The default (out-of-box) Enable password is Cisco.
Note

Clearing Manually Entered Controller Information

When you move your access point to a different location in your network, you must clear the manually
entered controller information to allow your access point to associate with a different controller.
This command requires the controller configured Enable password to enter the CLI EXEC mode.
Note
To clear or remove the manually entered controller information, you can use these EXEC mode CLI
commands:
clear lwapp ap ip address
clear lwapp ip default-gateway
clear lwapp controller ip address
clear lwapp ap hostname

Manually Resetting the Access Point to Defaults

You can manually reset your access point to default settings using this EXEC mode CLI command:
Note This command requires the controller configured Enable password to enter the CLI EXEC mode.
clear lwapp private-config

MODE Button Setting

The lightweight access point MODE button is configured from your Cisco Wireless LAN Controller. Use
these controller CLI commands to view and configure the MODE button:
1) config ap rst-button enable <access-point-name>/all
2) config ap rst-button disable <access-point-name>/all
3) show ap config general <access-point-name>
OL-8247-03
Where name is the access point name on the controller.
(Where access-point-name is the name that identifies the access point on the
ocntroller.)
Manually Configuring Controller Information Using the Access Point CLI
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
4-13