Cisco AIR-AP1252AG-A-K9 Hardware Installation Manual page 78

Low Power Condition on Autonomous Access Points
Table 3-5
commands for several power options.
Table 3-5 System Power Settings and Cisco Switch Commands for Access Points with a Single Radio Module
Power Source
AC power module
Cisco switch that supports
Intelligent Power Management
Cisco switch that does not
support Intelligent Power
1
Management
2
Power injector used with a
Cisco switch that supports
Intelligent Power Management
2
Power injector used with a
Cisco switch that does not
support Intelligent Power
1
Management
Power injector used with a
non-Cisco switch
1. You should check the release notes for your Cisco power source to determine which Cisco IOS release supports Intelligent Power Management. Support
for Intelligent Power Management might not be currently available for your Cisco power source.
2. Power injector must be AIR-PWRINJ4.
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
3-14
and Table 3-6 lists the access point system power settings and the Cisco switch power
Access Point System Power Settings
Configuration changes are not required
Power Settings:
1
Power Negotiation (selected)
Power Injector:
Installed on Port with MAC Address (unchecked)
Power Settings:
Pre-standard Compatibility (selected)
Power Injector:
Installed on Port with MAC Address (unchecked)
Power Settings:
Power Negotiation (selected)
1
Power Injector:
Installed on Port with MAC Address (unchecked)
Power Settings:
Power Negotiation (selected)
Power Injector:
Installed on Port with MAC Address (checked)
Configuration changes are not required
Chapter 3 Troubleshooting 1250 Series Autonomous Access Points
Cisco Switch
Power Command
power inline never
power inline auto
power inline auto
power inline never
power inline never
–
OL-8247-03