Manually Configuring Controller Information Using The Access Point Cli - Cisco AIR-AP1251AG-A-k9 Hardware Installation Manual

Aironet 1250 series

Table of Contents

Chapter 4

Troubleshooting 1250 Series Lightweight Access Points

Refer to

corresponding Cisco switch power command.

If the access point receives power through PoE, the output current of the power sourcing equipment

Caution

(PSE) cannot exceed 400 mA per port. The power source must comply with IEEE 802.3af.

Table 4-3

Using CLI Power Commands - Changes Needed ???

Power Source

AC power module

Cisco switch that supports Intelligent Power

Management

Cisco switch that does not support Intelligent

Power Management

Power injector

used with a Cisco switch that

supports Intelligent Power Management

Power injector

used with a Cisco switch that

does not support Intelligent Power

Management

Power injector used with a non-Cisco switch

802.3af compliant non-Cisco switches

1. You should check the release notes for your Cisco power source to determine which Cisco IOS release supports Intelligent

Power Management. Support for Intelligent Power Management might not be currently available for your Cisco power

source.

2. Power injector must be AIR-PWRINJ4.

3. Cisco switches that support Intelligent Power Management always configure the use of a power injector at the switch.

4. The access point detects the power injector (AIR-PWRINJ4).

Manually Configuring Controller Information Using the Access

Point CLI

In a new installation, when your access point is unable to reach a DHCP server, you can manually

configure needed controller information using the access point CLI. For information on how to connect

to the console port, see the

The CLI commands in this section can be used only on an access point that is not associated to a

Note

controller.

The static information configured with the CLI commands are used by the access point to connect with

a controller. After connecting with the controller, the controller reconfigures the access point with new

controller settings, but the static IP addresses for the access point and the default gateway are not

changed.

OL-8247-02

C I S C O C O N F I D E N T I A L - D r a f t A 1

Table 4-3

for information on when to use these special CLI controller commands and the

Cisco Wireless LAN Controller

None required

config ap power pre-standard enable

None required

A 1250 power injector is required

"Connecting to the Access Point Locally" section on page