Chapter 2
Installing the Access Point
The access point, antennas, and all interconnected equipment including the associated LAN
Warning
connections must be located indoors within the same building. Statement 375
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Statement 1040
Unpacking the Access Point
Follow these steps to unpack the access point:
Open the shipping container and carefully remove the contents.
Step 1
Return all packing materials to the shipping container and save it.
Step 2
Ensure that all items listed in the "Package Contents" section are included in the shipment. Check each
Step 3
item for damage. If any item is damaged or missing, notify your authorized Cisco sales representative.
Package Contents
Each access point package contains the following items:
•
•
•
•
•
OL-8247-03
Cisco Aironet 1250 series access point
Mounting hardware kit
One mounting plate, two 4 x 40 x 3/16 in screws, and a mounting plate latch (all attached to the
–
access point)
Two suspended ceiling T-rail clips, spacers (accommodates standard and recessed T-rails), and
–
nuts.
Four 8 x 18 x 3/4 in pan head Phillips sheet metal screws
–
Four #8 plastic wall anchors
–
One 10 x 24 nut (for ground stud on the mounting plate)
–
–
Two cable tie wraps
Product quick start guide
Product translated safety warning document
Cisco product registration and Cisco documentation feedback cards
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
Unpacking the Access Point
2-3