Cisco AIR-AP1252AG-A-K9 Hardware Installation Manual page 67

Chapter 3 Troubleshooting 1250 Series Autonomous Access Points
The LED signals are listed in
Regarding LED status colors, it is expected that there will be small variations in color intensity and hue
Note
from unit to unit. This is within the normal range of the LED manufacturer's specifications and is not a
defect.
Table 3-1 Autonomous Access Point LED Signals
Message type Ethernet LED
Boot loader status Green
Green
Off
Off
Off
Amber
Green
Green
Off
Association status —
—
Operating status Green
Blinking green
—
—
Blinking green
Boot loader warnings Off
Red
Amber
Off
Blinking green
OL-8247-03
Table 3-1.
Radio LED Status LED
Amber Off
Green Green
Red Off
Blinking green Blinking green Initialize Flash file system.
Green Green
Off White
Off Blinking blue
Green Blinking green Starting Cisco IOS.
Off Off
— Green
— Blue
— —
— —
Blinking green —
— Blinking blue
Blinking green Blinking green Access point location command.
Off Blinking red
Off Red
Off Blinking blue
Red Red
Blinking red Blinking pink
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
Checking the Autonomous Access Point LEDs
Meaning
DRAM test in progress.
DRAM memory test ok.
Board initialization in progress.
Flash memory test ok.
Initialize Ethernet.
Ethernet test ok.
Initialization ok.
Normal operating condition, but no wireless
client devices are associated with the unit.
Normal operating condition, at least one wireless
client device is associated with the unit.
Ethernet link is operational.
Transmitting or receiving Ethernet packets.
Transmitting or receiving radio packets.
Software upgrade in progress.
Ethernet link not operational.
Ethernet failure.
Configuration recovery in progress
(Mode button pressed for 2 to 3 seconds).
Image recovery
(Mode button pressed for 20 to 30 seconds).
Image recovery in progress and Mode button is
released.
3-3