Removing The Access Point From The Mounting Plate - Cisco AIR-AP1252AG-A-K9 Hardware Installation Manual

Removing the Access Point From the Mounting Plate

Removing the Access Point From the Mounting Plate

To remove the access point from the mounting plate when the mounting plate is attached to a surface,
follow these instructions:
Verify the location of the mounting plate latch (see
Step 1
Push the mounting plate latch with your right index finger while gently sliding the access point to the
Step 2
right with your left hand (see
Figure 2-22
2
1
Continue sliding the access point to the right while lifting the edge of the access point with your left
Step 3
hand.
Disconnect the access point cables.
Step 4
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
2-30
Figure
Pushing the Mounting Plate Latch
1
ETHERNET STATUS RADIO
Mounting plate latch
Figure 2-19).
2-22).
2
Direction to slide the access point
Chapter 2 Installing the Access Point
OL-8247-03