Inserting a Radio Module
Inserting a Radio Module
To install or remove a radio module, the access point must be removed from the mounting plate.
Note
Follow these steps to insert a radio module:
Step 1
Ensure the module latch is in the fully open position (see
Note
Step 2
Carefully insert the access point module rails into the radio module slots (see
Figure 2-26
1
2
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
2-34
If the module latch is not in the open position, the latch will not allow the module to be closed.
Inserting the Radio Module
1
Radio module slot on access point
Radio module
Figure
2-27).
2
3
4
3
Access point module rail
4
Radio module rail slot
Chapter 2
Installing the Access Point
Figure
2-26).
OL-8247-03