Configuring Controller Information; Clearing Manually Entered Controller Information - Cisco AIR-LAP1310G Mounting Instructions

Manually Configuring Controller Information Using the Lightweight Access Point CLI

Configuring Controller Information

Use these Exec mode CLI commands to manually configure controller information on a new access
point:
lwapp ap ip address <IP address> <subnet mask>
lwapp ip default-gateway IP-address
lwapp controller ip address IP-address
lwapp ap hostname name
Where name is the access point name on the controller.
The default Enable password is Cisco.
Note

Clearing Manually Entered Controller Information

When you need to move your access point to a different location in your network, you must clear the
manually entered controller information to allow your access point to associate with a different
controller.
This command requires the controller-configured Enable password to enter the CLI EXEC mode.
Note
You can use these EXEC mode CLI commands to clear or remove the manually entered controller
information:
clear lwapp ap ip address
clear lwapp ip default-gateway
clear lwapp controller ip address
clear lwapp ap hostname
Manually Resetting the Lightweight Access Point to Defaults
You can manually reset your lightweight access point to default settings using this EXEC mode CLI
command:
clear lwapp private-config
Note This command requires the controller configured Enable password to enter the CLI EXEC mode.
Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions
34
78-17634-01