Disarming Your System - DSC PC4020 - V3.3 Manual

Stay Arming
This feature, if enabled, will allow you to arm the perimeter zones while
leaving some interior zones inactive so that you can remain on the premises
while the system is armed. When you enter your access code to arm the
system and do not exit the premises through a designated exit/entry door,
the system will arm in the Stay mode, automatically bypassing the interior
zones.
The interior zones can be reactivated at any time by entering [
keypad. If you reactivate the interior zones, be sure that you do not enter
areas not protected by motion detectors. To access areas protected by
motion sensors, you must enter your security code to disarm the system.
Arming Without Entry Delay
The entry delay is the period during which someone may enter an armed
area without causing an alarm, providing time to get to a keypad to disarm
the system. If you wish to arm your system without the entry delay, enter
*
[ ][9] then your access code. The Armed light will flash as a reminder
that the system is armed and has no entry delay. The system will bypass
the interior zones. An entry through any exit/entry door will create an
instant alarm.
Quick Arm
When the Quick Arm feature is enabled, you can arm the system by
pressing [ * ][0], instead of your access code.
Please note that pressing [
disarm, you must enter a valid access code. Your system administrator
will inform you if the Quick Arm feature has been enabled on your system.

1.4 Disarming Your System

1. Enter the premises through a designated exit/entry door. Entering
the premises through any door not designated as a point of entry
will cause an immediate alarm. As soon as the exit/entry door is
opened, the keypad sounder will beep and the entry delay will begin.
The entry delay provides up to 255 seconds to disarm the system.
2. Go to the keypad and enter your access code. If you make an error
when entering the code, press the [#] key and enter the code again. when entering the code, press the [#] key and enter the code again.
when entering the code, press the [#] key and enter the code again. when entering the code, press the [#] key and enter the code again. when entering the code, press the [#] key and enter the code again.
The Armed light will turn off and the keypad buzzer will stop. A
valid access code must be entered before the entry delay time expires.
If an alarm occurred while the panel was armed, the "View Memory"
message will be on the display with the zone name for the zone that caused
the alarm. The display will keep those messages on for two minutes or
until the [#] key is pressed. The keypad will then return to it's idle state.
S e c t i o n 1 : G e n e r a l
* ][0] will only allow you to arm the system; to
S y s t e m O p e r a t i o n
* ][1] at any
If you make an error If you make an error
If you make an error If you make an error
7