Audible Exit Faults; To Correct An Exit Fault; Disarming The System; Disarming Error - DSC neo HS2064 E User Manual

Chapter 3

3.9.2 Audible Exit Faults

Note: Must be enabled by installer.
In an attempt to reduce false alarms, the Audible Exit Fault notifies you of an improper exit when arming the system. Improper
exits are caused by failing to securely close the Exit/Entry door.
Improper exits cause the following system notifications:
The keypad emits one continuous beep.
l
The bell or siren sounds for the duration of the entry delay until a valid user code is entered or until the programmed Bell
l
time out expires.

3.9.3 To Correct an Exit Fault

1. Re-enter the premises.
2. Disarm the system before the entry delay timer expires by entering your [access code].
3. Follow the Away arming procedure again, making sure to close the entry/exit door properly. For more details see: "Away
Arming the System with the Keypad".

3.10 Disarming the System

Depending on your system configuration, there are multiple methods you can use to disarm your system. You can disarm the system
using a:
2-way wireless key
l
Proximity tag
l
To Disarm the System with a Keypad
1. Enter your [access code] or present your proximity tag anytime the system is armed . (Armed
on).
2. If you walk through the entry door, the keypad will beep. Disarm within _____ seconds to avoid an alarm con-
dition.
To Disarm the System with a 2-way Wireless Key
1. Press the disarm button anytime the system is armed. (Armed
2. If you walk through the entry door the keypad will beep. Press the disarm button within ____ seconds to avoid an alarm con-
dition.
Note: After disarming a system with an HS2LCD keypad using a 2-way wireless key, always check the alarm memory to determ-
ine if any alarms have occurred during the armed period.
To Disarm the System with a Proximity Tag
1. Present your proximity tag to a keypad equipped with a proximity sensor anytime the system is armed . (Armed
is on) and if configured as required, enter your access code.
2. If you walk through the entry door the keypad will beep. Present your proximity tag within
_____ seconds to avoid an alarm condition.
Note: Duration of Entry timer is programmed by installer. The installer will advise the maximum duration of entry delay that was
programmed in the system. It cannot exceed 45 seconds.

3.10.1 Disarming Error

If your code is invalid, the system will not disarm and a 2-second error tone will sound. If this occurs, press [#] and re-enter your
access code.
indicator is on).
- 14 -
indicator is
indicator