Zone Bypassing [ ]+[1] - DSC PC 4010 Manual

ZONE BYPASSING
[ ]+[1]
A bypassed zone will not cause an alarm. If a zone is bypassed the panel
may be armed even if the zone is open. Use zone bypassing when access
is needed to part of the protected area. Also, damaged wiring or contacts
on a zone may be temporarily bypassed until repairs can be made so that
the panel can be armed.
To bypass zones, enter [ ] [1]. An access code may be required if the
installer has enabled that option. A menu will appear.
[0] Bypass Zones - This selection takes you immediately to bypassing
zones. Use the [<] [>] to select the zones to be bypassed and press the [ ]
key to select the zone. A " " will appear beside the zone label to indicate
the zone will be bypassed when the partition is armed.
A zone search routine allows the user to find the desired zone to bypass by
entering in the first letter of the zone to search for, and pressing one of the
[<][>] keys. The [>] key will search for the first zone on the partition that
begins with the letter selected. Pressing the [>] key again will search for the
next zone on the partition that begins with the letter selected.
The letters of the alphabet have been divided up among the 1-9 number
keys on the keypad.
1 2 3
ABC1 DEF2 GHI3
4 5 6
JKL4 MNO5 PQR6
7 8 9
STU7 VWX8 YZ90
0
CLEAR
[1] Clear Bypasses will remove bypasses from all the zones in your partition
and then takes you to bypassing zones. None of the zones will have a " "
beside them.
[2] Recall Bypasses will bypass all the same zones selected for the last
time zone bypassing. This is for users who always bypass the same zones.
[3] Previous Menu takes the user back to the "Enter Code to Arm System".
When the PC4010 was programmed, the ability to bypass certain zones may
have been eliminated by the installer. In this case, the " " message for
those zones will not come on in response to the bypass command. Zone
bypasses are automatically cancelled when the panel is disarmed.
Note: At no time can any armed zone be bypassed.
17