Alarm Memory Display [ ]+[3]; Sensor Reset [ ]+[4] When Disarmed; User Functions Command [ ]+[6]+[Access Code] - DSC PC 4010 Manual

Zn LwBatt Fault - This trouble condition will occur when a wireless zone
has a low battery condition. To view which zone has the trouble press the
[ ] key while viewing the trouble condition. The zone(s) with the trouble
condition will be displayed in numerical order on the display. A keypad
trouble is generated when the system is disarmed and a visual "Zn Low Batt
Fault" trouble and trouble reporting code will be transmitted.
Automation Fault - This trouble condition will occur well the Escort 4580 losses
communication with the Automation Output control module. An audible trouble
(VIA keypad buzzer) will be generated as well as the trouble LED activating for
the keypads. An Automation Fault trouble reporting code will be sent to the
monitoring station if programmed. If there is an AC trouble present at the time
the panel will not transmit the Automation Fault reporting code.
Printer Off-Line - This trouble condition will occur if the serial printer
connected to the PC4400 serial interface module goes off-line.
PC4400 Trouble - This trouble will be displayed when a DVAC Fault occurs
(The DVAC line from central station is not present), or a Module Fault occurs
(The PC4400 module has failed an internal diagnostics), or if DVAC
communications has been shut down by central.
ALARM MEMORY DISPLAY
[ ]+[3]
Press [ ] then [3] to enter the alarm memory mode. Any alarm caused during
the last armed period will be displayed. The "Alarm Memory" message will
only be displayed when an alarm occurred during the last armed period.
Press [#] to return to "Ready".
Note: Tamper alarms will not be shown in alarm memory display.
SENSOR RESET
[ ]+[4] When Disarmed
Entering [ ] [4] [access code] will reset smoke detectors assigned to that
partition. The message "Sensor Reset In Progress..." will be displayed,
along with a countdown in the lower right corner. Your installer may program
the sensor reset option so that an access code is required.
USER FUNCTIONS COMMAND
[ ]+[6]+[ACCESS CODE]
Enter [ ][6][Access Code] and then use the [<][>] keys to display the items
of the function menu. Press [ ] to select an item.
[0] Quick Arm
[3] Keypad Setup
[6] Spec. Messages
[1] Quick Exit [2]Auto Arm Control
[4] Bell/Comm Test [5]Door Chime
[7] User Call Up
21