Table of Contents
Advertisement
Turning the door chime on or off
If your installer has enabled the door chime feature, your PC5502Z2 keypad will sound a tone
whenever designated doors or windows are opened or closed. Your installer has programmed
which doors and windows will activate the door chime.
1.
Press
to turn the door chime feature ON. The keypad will beep 3 times.
2.
Press
again to turn the door chime feature OFF. The keypad will sound one long beep.
Programming access codes
Your PC5502Z2 keypad has two 4-digit access codes. Your installer will give you the Master
code. The Master code can be used to arm and disarm the system, access system features, and
to program the regular access code. The regular access code can only be used to arm and dis-
arm the system, and access system features.
To program the Master code, or the regular access code:
1.
Press
[current Master Code]
2.
To program the Master code, press [1]. To program the regular access code, press [2]. Zone lights
1 or 2 will flash, depending on which code you have chosen to program.
3.
Enter the new code. Access codes must have four digits. Enter digits 0 through 9 only.
CAUTION: Do not use obvious codes such as [1111] or [1234].
4.
To exit access code programming, press
5.
Record your new codes on the "System Information" section in this booklet.
Bypassing zones
Use the zone bypassing feature when you will need access to a protected area while the sys-
tem is armed, or when a zone is temporarily out of service, but you need to arm the system.
Bypassed zones will not be able to sound an alarm. Zones cannot be bypassed once the
system is armed. Bypassed zones are automatically cancelled each time the system is disarmed
and must be bypassed again before the next arming.
NOTE: For security reasons, your installer may program the system to prevent you
from bypassing certain zones.
Bypassing zones reduces your security protection. If you are bypassing a zone because
it is not working, call a service technician immediately so that the problem can be
resolved and your system returned to proper working order. Make sure that no zones
are unintentionally bypassed when arming your system.
1.
Start with the system in the Ready state. Press
2.
Enter the number of the zone to be bypassed (1 or 2). When a zone is bypassed, the corre-
sponding zone light will turn ON.
3.
If a zone is bypassed by mistake, enter that zone number again; the zone light will turn OFF, indi-
cating that the zone is not bypassed.
4.
To exit bypassing mode and return to the Ready state, press
T u r n i n g t h e d o o r c h i m e o n o r o f f
.
.
.
5
Advertisement
Table of Contents
