Table of Contents
Advertisement
7. If you disconnected any power cords or external cables from the server,
Connecting the cables
This section provides basic information about attaching peripheral devices such as
a monitor, keyboard, and pointing device to the server and connecting the server to
additional servers.
Note: You can connect a USB keyboard to the server using one of the USB
Input/output connectors
Your server has the following input/output (I/O) connectors:
v Serial (one, rear)
v Gigabit Ethernet (two, rear)
v Keyboard (one, rear)
v Mouse (one, rear)
v USB (two, rear; one, front - on operator information panel)
v RXE expansion (one, rear)
v RXE management (one, rear)
v SCSI (one, rear)
The Remote Supervisor Adapter II has the following connectors:
v Remote Supervisor Adapter II Ethernet (one, rear)
v Remote Supervisor Adapter II video (one, rear)
v Remote Supervisor Adapter II ASM (one, rear)
v Remote Supervisor Adapter II USB (reserved)
The following illustration shows the USB connector on the operator information
panel on the front of the server.
server configuration. See "Updating the server configuration" on page 29
and the User's Guide for more information.
reconnect the external cables first. If you are adding any new peripheral devices
(see "Connecting the cables" for details), you can connect the external cables
for those devices. Then, connect the power cords to properly grounded
electrical outlets.
connectors. After installing a USB keyboard, you might need to use the
Configuration/Setup Utility program to enable keyboardless operation and
prevent POST error message 301 from being displayed during startup. For
detailed information about the USB keyboard and how to connect it to your
server, see the documentation that comes with the keyboard.
USB connector
Chapter 2. Installing options
27
Advertisement
Table of Contents
