Using User Programs - Brother BAS-300G Instruction Manual

6. USING THE OPERATION PANEL (ADVANCED OPERATIONS)

6-7. Using user programs

Up to 50 different combinations of settings including program no., X-scale, Y-scale, sewing speed, work clamp height and
intermittent presser foot height can be memorized as user programs (U1 to U50). (However, the work clamp height setting is
only enabled for motor-driven work clamp specifications.）
If you are sewing certain patterns over and over again, it is useful to record the settings for these patterns into a user
program.
User programs are enabled when memory switch no. 400 is set to "ON".
<Recording user programs>
1
Select a user program number.
TEST indicator illuminates, MENU indicator flashes
2
First, set the program number.
3
Next, set the X-scale.
4
Next, set the Y-scale.
5
Next, set the sewing speed.
39
X-SCALE indicator flashes
Y-SCALE indicator flashes
SPEED indicator flashes
BAS-300G, BAS-311G, BAS-326G
While pressing the TEST key, press the SELECT key.
• Switch to user program recording mode. Check that
the menu indicators are flashing.
• The user program number will appear in the
PROGRAM No. display, and " P- - - " will appear in the
menu display.
or
Press the key to select the user program
number.
Press the or key to set the user program number
to be recorded.
NOTE:
Select a program number that is recorded in the
internal memory. You cannot specify program
numbers on removable media.
Press the SELECT key.
Press the or key to set the X-scale to be recorded.
Press the SELECT key.
Press the or key to set the Y-scale to be recorded.
Press the SELECT key.
Press the or key to set the sewing speed to be
recorded.
4469Q
4966Q
4470Q
4472Q
4474Q