Replacing The Bezel - IBM 84885BU Maintenance And Troubleshooting Manual

Replacing the bezel

Complete the following steps to replace the bezel.
Note: For hot-swap hard disk drive models, make sure the side cover is unlocked;
1. Insert the tab on the left side of the bezel into the matching hole on the chassis
2. Slide the bezel toward the bottom of the server until you can insert the two
3. Push the top of the bezel toward the server until the two tabs at the top of the
4. For hot-swap hard disk drive models, slide the lock bar to the right. The
5. Lock the side cover.
Openings
then, slide the lock bar on the bezel to the left (unlocked) before you begin.
left front.
openings on the bottom rear of the bezel onto the matching hooks on the server
chassis.
bezel snap into place.
hot-swap lock bar locks when you lock the side cover key lock.
Release
tab
Bezel
Tab
Hooks
Chapter 4. Customer replacement units
31