Top/Side Cover - IBM 84885BU Maintenance And Troubleshooting Manual

Top/side cover

Before you begin:
v Read Appendix B, "Safety information," on page 143.
v Review the information in "System reliability guidelines" on page 25.
To remove the top/side cover, complete the following steps:
1. Turn off the server, if it is on.
2. Disconnect the power cord from the power source and from the server; then,
3. Remove the side cover (see "Removing the side cover" on page 28).
4. Remove the front bezel (see "Removing the bezel" on page 30).
5. Remove the handle assembly (see "Handle assembly" on page 95).
6. Remove the four screws from the back of the server and put them in a safe
7. Using a screwdriver, gently pry the cover away from the server in the rear and
To replace the top/side cover, reverse the steps.
92
xSeries 226 Type 8488 and 8648: Hardware Maintenance Manual and Troubleshooting Guide
disconnect all external cables.
place.
slide the unit away from the server.