Tpm Scenarios - HP Integrity rx2800 - i2 User Manual

Close all the windows, and then start the firmware update.
6.
To enable advanced startup options, use the following command:
cscript manage-bde.wsf -protectors -disable c:
When the firmware update process is completed, the BitLocker Drive Encryption support can be re-
enabled by following steps 1 through 4 but clicking Enabled in step 5 instead. The following command
can be used to re-enable BitLocker Drive Encryption after firmware deployment has completed.
cscript manage-bde.wsf -protectors -enable c:

TPM scenarios

The following table discusses the TPM detection scenarios that you might encounter.
Scenario
If the TPM is detected and enabled, the
installation is not silent, and a system ROM must
be updated.
If the TPM is detected and enabled, the
installation is silent, the /tpmbypass switch is not
given, and any firmware updated must be
applied to the server.
If the TPM is detected and enabled with Option
ROM Measuring, the installation is not silent, and
a system ROM must be updated.
Result
A pop-up warning message appears. After OK is
selected, you can continue. The installation is not
canceled.
No pop-up warning appears. A new log file is
generated
(%systemdrive%\cpqsystem\log\cpqstub.log).
Because the installation is silent, the installation is
terminated and cannot continue.
A pop-up warning message appears. After OK is
selected, you can continue. The installation is not
canceled.
Introduction 22