HP Integrity rx2800 - i2 User Manual page 69

Command-line
argument
/on_failed_dependen
cy
Reboot options
/r[eboot]
/reboot_message
"reboot message"
/reboot delay
timeout_in_seconds
/reboot_always
Creating host groups
/group "group_name"
Simulating HP SUM
/dryrun
Targets
/user <username> or
/username <username>
/psswd <password>
Description
This argument informs HP SUM how to proceed when a component has a
failed dependency.
The default of OmitHost causes the host to be put in a failure state and no
install is attempted on it.
OmitComponent clears the affected components and proceeds with any
updates that do not have dependency failures.
Force attempts all updates, even if they have dependency failures.
If the following conditions are met, then this argument causes the server (or
host server in a remote installation) to reboot:
•
The /reboot option is selected or given as a command-line argument.
•
All components selected for installation are successfully installed.
•
At least one of the installed components requires a reboot to complete its
installation.
This argument displays the specified reboot message on remote consoles
connected to the server you want to reboot. You must use this argument with
the /reboot option or the argument is ignored.
This argument delays the reboot of the server for the length of time specified
by the timeout_in_seconds variable. You must use this argument with the
/reboot option, or the argument is ignored. Acceptable values are between
15 and 3600.
•
The default timeout value is 15 seconds for Microsoft® Windows®
operating systems and 60 seconds for Linux.
•
For Linux, the Reboot Delay time is converted from seconds to minutes,
and any value under a full minute, 59 seconds or less, rounds to the next
minute.
•
If the following conditions are met, then this argument forces the server to
reboot: The /reboot_always option is selected or given as a
command-line argument.
•
All components selected for installation are successfully installed.
This argument specifies an already defined group name in the HP SUM GUI.
This argument simulates the installation for a test run. Nothing is installed.
This argument enables you to log in to the remote targets (except for the OA
associated with VC target) with the user ID.
For the OA associated with VC target, see /oa_username argument.
This argument enables you to use the password for the user ID specified in the
/user argument to log in to remote targets (except for the OA associated
with VC target).
For the OA associated with VC target, see /oa_password argument.
Scripted deployment 69