HP Integrity rx2800 - i2 User's & Service Manual page 91

Table 42 I/O card events that may light SID LEDs
Diagnostic Sample IPMI Events
LEDs
I/O Card Type E0h, 4658d:26d
IO_PCI_POWER_OVERLOAD_ERR
I/O Card Type E0h, 137d:26d
IO_NOT_ENOUGH_POWER_ERROR
I/O Card Type E0h, 147d:26d
IO_SLOT_STANDBY_POWER_ERROR
I/O Card Type E0h, 131d:26d
IO_HOT_PLUG_CTRL_FAILED
I/O Card Type E0h, 139d:26d
IO_PCI_MAPPING_TOO_BIG
I/O Card Type E0h, 148d:26d
IO_UNKNOWN_PCIXCAP_VAL
I/O Card Type E0h, 141d:26d
IO_PCIXCAP_SAMPLE_ERROR
I/O Card Type E0h, 123d:26d
IO_CHECK_LBA_MISSING_ERR
I/O Card Type E0h, 619d:26d
IO_CHECK_LBA_DECONFIG_ERR
I/O Card Type E0h, 133d:26d
IO_LBA_CLEAR_ERR_FAILED
I/O Card Type E0h, 144d:26d
IO_SBA_CLEAR_ERR_FAILED
I/O Card Type E0h, 146d:26d
IO_SLOT_POWER_ON_ERROR
I/O Card Type E0h, 145d:26d
IO_SLOT_POWER_DEFAULT_ERROR
I/O Card Type E0h, 136d:26d
IO_LBA_RESET_ERROR
Cause Source
A non hot plug I/O SFW
slot power
consumption increases
the total I/O power
consumption beyond
the supported limit
Insufficient power to SFW
power on a hot-plug
PCI-X slot
PCI slot standby SFW
power failed
PCI-X hot-plug SFW
controller failed
PCI bus walk (I/O SFW
discovery) resources
exceeded
Found invalid SFW
PCIXCAP value
PCIXCAP sampling SFW
error
Expected I/O host SFW
bridge (Lower Bus
Adapter) is missing
Expected I/O host SFW
bridge (Lower Bus
Adapter) is
deconfigured
I/O LBA clear error SFW
failed
I/O SBA clear error SFW
failed
PCI-X slot power on SFW
error
PCI-X slot has incorrect SFW
default power state
I/O host bridge SFW
(Lower Bus Adapter) is
inaccessible because
rope reset failed to
complete
Troubleshooting the I/O
Notes
Disallow O/S
boot and display
the following
UEFI error
message, "I/O
configuration
exceed"
Display UEFI
warning message
"Failed I/O slots
deconfigured"
Either a card /
slot problem.
Re-seat card first.
Either a card /
slot problem.
Re-seat card first.
Remove any
unsupported I/O
cards. Move I/O
card to an
unused PCI slot
91