B Utilities
SAS disk setup
Using the saupdate command
The saupdate command is used to query or change the mode of the Smart Array P410i and
Smart Array P41 1 controllers to HBA or RAID. Querying or changing modes is not supported for
other controllers.
The newly added commands to SAUPDATE are:
Get Mode
Set Mode
Get mode
This command displays the current mode of the controllers.
Syntax
saupdate get_mode <controller>
<controller> can be any one of the following strings.
Table 49 <controller> strings
<controller>
<seg:bus:dev:func>
all
<model>
132 Utilities
Meaning
A controller having the PCI segment id, bus id, device id and function id is addressed
Addresses all controllers in the system
Controllers of a particular type indicated by the <model> string are addressed