Onnecting To The N Earby Tv (Tv1) - Dish Network Duo ViP 222 User Manual

Chapter 11
Connecting to the Nearby TV (TV1)
C
ONNECTING TO THE
This section describes how to connect receiver TV1 output ports to a nearby TV. Select one of the
following methods.
Note: If you would like to put the receiver in a remote location (closet, cabinet, etc.), be sure to get
the replacement remote control that uses UHF Pro signals to control TV1. Call your DISH Network
retailer or go to www.dishnetwork.com, select Shop, and then click on Accessories.
HDMI Connections
The HDMI connection delivers high-quality audio and video to your HDTV or HD Monitor using one
cable. If your HDTV or monitor has an HDMI input available, this is the recommended connection.
1
Connect an HDMI cable between the receiver and HDTV set or monitor.
2
Turn on your receiver and TV using their front-panel controls.
3
Confirm that you are seeing a picture from the receiver. Consult your HDTV user's guide if you
need to change your HDTV source or input setting to display from the HDMI input.
4
If you do not see a picture, see No Picture on the nearby TV on page 87. Refer to Setting Up to
Display in HD on page 88.
Note: In most cases, connecting the HDMI cable will provide plug-and-play control of the HDTV or
monitor's display resolution and other settings. However, your HDTV may require that you select a
different format to display from the receiver during setup.
5
Turn up the volume on your HDTV and confirm you hear sound. If you don't hear any sound, then
your system may require you to connect audio (red and white) RCA-type cables between the
receiver Audio Outputs and TV's audio input connections.
86
N
EARBY
1
HDMI
Connect receiver
and monitor with
HDMI cable
TV (TV1)
2-4
Turn monitor
and receiver on
and confirm picture
5
Confirm
sound and
volume