Dish Network Duo ViP 222 User Manual page 67

Checking the Remote Control Address
You can see what address is programmed into the remote control by completing the
following instructions.
1
Press and hold the SAT mode button for about three seconds, until all of the mode buttons
light up, and then release the SAT button.
2
Press POUND (#) twice. The SAT mode button will flash the same number of times as the
programmed remote-address number (for example, three flashes for address 3).
Confirming Remote Control Operation
Complete the following from the nearby TV to verify the remote operates the receiver:
1
Make sure the remote contains fresh batteries and is in SAT mode (to verify, press the
SAT Mode button and it should light for a few seconds and then dim).
2
Press SYSTEM INFO on the receiver front panel to display the System Information screen
on the nearby TV.
3
Press RECORD on the remote control:
• Remote Control 1—The Primary Remote Address in the System Information screen
changes to match the address preset in your TV1 remote control. Typically, the TV1
remote control for the nearby TV is IR only, unless you have received an IR/UHF Pro
replacement remote control (for example, to operate a receiver installed in a closet).
• Remote Control 2—The Secondary Remote Address in the System Information
screen changes to match the address that is preset in your TV2 remote control.
4
Press the POWER button on each remote control to turn on/off the receiver.
5
After verifying remote operation, select Done to close the System Information screen.
Remote Controls
Improving Receiver Control
59