Dish Network Duo ViP 222 User Manual page 100

Chapter 11
Connecting to the Remote TVs (TV1 or TV2)
The figure below shows an example of what a splitter may look like. Your splitter may look a bit
different. The places where the splitter indicates O
coax cabling system. The places where the splitter indicates I
example, from your satellite receiver) is fed into the splitter.
17
Find where the TV signal is distributed throughout your home. It should be near where the cable
TV service enters the house.
18
Disconnect the cable TV service cable or antenna cable from the splitter input, if necessary. Make
sure that the disconnected cable is capped or otherwise protected from the weather.
19
Disconnect the cable coming from the receiver H
you do not know which cable this is, then continue with the next step. Otherwise, skip to step 21.
20
If you have multiple TVs on the home cabling system, do the following to determine which coaxial
cable on the splitter is coming from the receiver:
• If you see at least some video on your TV(s), turn on all remote TV(s) connected to the home
cable system. Disconnect and reconnect each cable one-by-one, observing what happens to
the TVs. When all remote TV(s) lose the signal, you have disconnected the receiver's cable. If
only some of or one TV(s) loses the signal, then you have disconnected a cable from the TVs.
• If the preceding does not work, then disconnect one of the output cables and connect to the
splitter input. If you do not see a picture, connect the cable back to its output. Repeat this task
on every connection until you can see video from the receiver on the remote TV(s).
21
Reconnect the receiver's coaxial cable to the input of the splitter.
22
Make sure you have a good picture on your remote TV(s).
23
If desired to remind you of which TV channel your satellite programming is on, write the channel
number you wrote in step 5 on a blank channel sticker and place it on or near your remote TV(s).
The stickers are inside the front cover of this guide.
24
Confirm Remote Control 2 (or Remote Control 1 with a Green UHF Pro key, sold separately)
controls the receiver. See page 59 for instructions.
25
Program the RECOVER function for Remote Control 2 (or Remote Control 1 with a Green UHF
Pro key, as sold separately) to the channel you selected in step 5. See page 71 for instructions.
92
1 Input, 4 Output (4-Way) Splitter
refers to all TVs connected to your home's
UT
refers to where the TV signal (for
N
D output jack from the splitter. If
OME ISTRIBUTION