PRESONUS STUDIOLIVE 24.4.2 Owner's Manual page 131

Owner's Manual
Shelving EQ
Graphic EQ
A broad bandwidth accentuates or attenuates a larger band of frequencies. The
broad and narrow bandwidths (high and low Q) are usually used in conjunction
with one another to achieve the desired effect. Let's look at our kick drum again.
We have a kick drum that has a great, big, low-end sound centered around 100
Hz and an attack hitting almost dead-on at 4 kHz. In this example, you would
use a broad bandwidth in the low frequency band, centered at 100 Hz, and
a narrow bandwidth boosted at 4 kHz. In this way you are accentuating the
best and downplaying everything else this particular kick drum has to offer.
A shelving EQ attenuates or boost frequencies above or below a specified cutoff
point. Shelving equalizers come in two different varieties: high-pass and low-pass.
Low-pass shelving filters pass all frequencies below the specified
cutoff frequency while attenuating all the frequencies above it. A
high-pass filter does the opposite: passing all frequencies above the
specified cut-off frequency while attenuating everything below.
The StudioLive 24.4.2 features 4 stereo, 31-band, graphic EQs that can be inserted
on a variety of buses. (See Section 5.3 for details.) A graphic EQ is a multiband
equalizer that uses sliders to adjust the amplitude for each frequency band. It
gets its name from the positions of the sliders, which graphically display the
resulting frequency-response curve. As explained in Section 5.3, the encoders
in the Fat Channel are used to make amplitude adjustments, and the meter
LEDs display the "slider" positions. The center frequency and bandwidth are
fixed; the level (amplitude) for each band is the only adjustable parameter.
Graphic EQs are generally used to fine-tune the overall mix for a particular
room. For instance, if you are mixing in a "dead" room, you may want to boost
high frequencies and roll off some of the lows. If you are mixing in a "live"
room, you might need to lower the high-midrange and highest frequencies. In
general, you should not make drastic amplitude adjustments to any particular
frequency bands. Instead, make smaller, incremental adjustments over a wider
spectrum to round out your final mix. To assist you with these adjustments, here
is an overview of which frequencies affect different sound characteristics:
Sub-Bass (16 Hz to 60 Hz). These very low bass frequencies are felt, rather
than heard, as with freeway rumbling or an earthquake. These frequencies give
your mix a sense of power even when they only occur occasionally. However,
overemphasizing frequencies in this range will result in a muddy mix.
Bass (60 Hz to 250 Hz). Because this range contains the fundamental notes
of the rhythm section, any EQ changes will affect the balance of your mix,
making it fat or thin. Too much emphasis will make for a boomy mix.
Tutorials 8
Equalizers 8.3
131