Figure 71: Attaching A Cable To A Pic - Juniper T640 Hardware Manual

Hide thumbs Also See for T640:

Table of Contents

Documentation

CAUTION: Avoid bending fiber-optic cable beyond its minimum bend

radius. An arc smaller than a few inches in diameter can damage the cable

and cause problems that are difficult to diagnose.

CAUTION: Do not let fiber-optic cable hang free from the connector. Do

not allow fastened loops of cable to dangle, which stresses the cable at

the fastening point.

Figure 71: Attaching a Cable to a PIC

T640 Craft Interface Description on page 41

Tools and Parts Required to Connect the T640 Router to External Devices on page 117

T640 Routing Engine Interface Cable and Wire Specifications on page 365

Chapter 12: Connecting the T640 Router to External Devices