Table of Contents
Advertisement
Installation Guide for the Model SW510 and Model SW518 Ethernet Switches
1
2
18
PORT
Ethernet Switch
10/100Mbps
1
2
3
4
5
6
7
8
9
10 11 12
13 14 15
16
Power
Green = Rx/Tx Yellow = Collision
Key:
1 = Power LED
2 = Rx/Tx and Collision LEDs for ports 1 through 18
3 =100 Mbps LEDs for ports 17 and 18
4 =10 Mbps Ethernet ports with Link and FDX LEDs on each port
5 = Normal/Uplink push button to configure port 16
6 =10/100 Mbps Ethernet ports 17 and 18 with Link and FDX LEDs on each port
7 = Normal/Uplink push button to configure port 18
Figure 2-2.
Front panel of the Model SW518 switch
Ethernet Ports
The Model SW510 switch is equipped with eight 10 Mbps Ethernet ports and two 10/100 Mbps
Fast Ethernet ports. On the Model SW518 switch, there are sixteen 10 Mbps ports and two 10/100
Mbps ports. A server or PC can be connected to any of the ports.
The 10/100 Mbps ports are Ports 9 and 10 on the Model SW510 switch and Ports 17 and 18 on the
Model SW518 switch. The network access speed for the two 10/100 Mbps ports on both systems is
automatically sensed and displayed on the front panel by the 100 Mbps LEDs.
The 10 Mbps and 10/100 Mbps ports support only one cable connection, which is for unshielded
twisted pair (UTP) cable. An 8-pin RJ-45 plug is used for connection to this port.
2-2
3
1
Link
FDX
100 Mbps
17 18
9
4
10/100 Mbps
8
Normal/Uplink
16
5
6
7
MODEL
SW518
10/100 Mbps
Link
FDX Link
FDX
Normal/Uplink
17
18
593EA
Physical Description
Advertisement
Table of Contents
