NETGEAR SW518 - Switch Installation Manual page 11

Installation guide
Hide thumbs Also See for SW518 - Switch:
Table of Contents

Advertisement

Two 10/100 Mbps ports on each of the switches
One of the 10/100 Mbps ports is configurable as Normal (MDI-X) or Uplink (MDI).
Switch-selectable half/full-duplex mode for the 10 Mbps ports
In full-duplex mode, the throughput of point-to-point connections is doubled by enabling
individual ports to transmit and receive concurrently when the other end also supports
full-duplex mode.
Auto- or full-duplex mode for the 10/100 Mbps ports:
— Auto-negotiable between full-duplex and half-duplex mode when set in auto-duplex mode
The mode will default to half-duplex transmission if the remote end cannot provide a
proper signal to indicate its own capability.
— Can be set to full-duplex mode permanently for interoperability with legacy 100BASE-TX
devices
Wire-speed filtering and forwarding to provide "traffic cop" function by directing traffic to the
appropriate route without slowing down the traffic
Plug-and-Play operation with no software to configure
Low latency store-and-forward transmission mode with leading edge to leading edge of less
than 75 s
Ten vista RJ-45 connector ports on the Model SW510 and eighteen vista RJ-45 connector
ports on the Model SW518 switch
Each port has built-in LEDs to monitor individual port status.
Comprehensive LED indicator panel to monitor overall switching condition
Auto address learning function to build the routing information database
The routing table contains 8,000 Ethernet address entries per port to store MAC addresses for
attached network nodes.
2-megabyte (MB) buffer provided for the 10 Mbps ports on the Model SW518 and 1 MB
buffer provided for the 10 Mbps ports on the Model SW510, with an additional 2 MB of buffer
memory for the two 10/100 Mbps ports
Conformity to the ISO/IEC 8802-3 and ANSI/IEEE 802.3 10BASE-T standards
Conformity to the IEEE 802.3u 100BASE-TX standard
Rack Mount Kit provided for installing the switch in a standard 19-inch rack
Introduction
Installation Guide for the Model SW510 and Model SW518 Ethernet Switches
1-3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sw510

Table of Contents