Juniper ADVANCED INSIGHT SCRIPTS 2.5 - RELEASE NOTES REV 1 Release Note page 17

Table 1: Events Detected by AI-Scripts (continued)
EVENT ID
KERNEL:ifd_request: RTM_ID.*
KERNEL:ifd_request: RTM_ID.*
KERNEL:parity error detected, fll reinit: mpfe.*
KERNEL:pfestat_req_receive: request.*
KERNEL:Process .* has exceeded 85% of
RLIMIT_DATA
KERNEL:rdp retransmit error
KERNEL:RT_PFE: NH IPC failed, err 6 (No
Memory)
KMD_SNMP_PIC_NO_RESPONSE
L2ALD_IPC_PIPE_WRITE_ERROR
L2ALD_PIP_IFD_READ_RETRY
L2CPD_ABORT
L2CPD_ASSERT
L2CPD_ASSERT_SOFT
L2CPD_PPM_WRITE_ERROR
©
Copyright 2010, Juniper Networks, Inc.
DESCRIPTION
Some Junos daemons were not originally included in a list of processes that
can modify an inteface definition. These messages are only informational
and can be ignored.
Some Junos daemons were not originally included in a list of processes that
can modify an inteface definition. These messages are informational only
and can be ignored.
The message indicates that the Packet Forwarding Engine was reset when
detecting a parity error in the ASIC.
Kernel message regarding PFE statistics counter request.
This message indicates that the virtual memory size of a process's data-
segment area (RLIMIT_DATA) has exceeded its current soft limit.
The kernel is indicating that no system buffer space is available.
The kernel is reporting that the Packet Forwarding Engine cannot install or
change routing table entries because it is running out of memory.
The indicated PIC did not respond to a request from the key management
process (kmd) for Simple Network Management Protocol (SNMP) statistics
about IP Security (IPSec) security associations.
The Layer 2 address learning process (l2ald) could not write to an
interprocess communication (IPC) pipe for the indicated reason.
The Layer 2 address learning process (l2ald) could not read the provide-in-
provider interface (pip0) interface from the kernel.
The Layer 2 Control Protocol process (l2cpd) terminated because of an
internal error.
The source code for the Layer 2 Control Protocol process (l2cpd) includes
internal self-consistency tests. l2cpd with the indicated executable name
and process ID (PID) terminated because the indicated test failed at the
indicated line number in the indicated source file. The process created a
diagnostic core file for analysis by technical support personnel.
The source code for the Layer 2 Control Protocol process (l2cpd) includes
internal self-consistency tests. l2cpd with the indicated executable name
and process ID (PID) terminated because the indicated type of check failed
at the indicated line number in the indicated source file. The process
continued to run, but created a diagnostic core file for analysis by technical
support personnel.
The Layer 2 Control Protocol process (l2cpd) could not write a message on
the pipe to the periodic packet management process (ppmd).
Events Detected by AI-Scripts
17