Juniper ADVANCED INSIGHT SCRIPTS 2.5 - RELEASE NOTES REV 1 Release Note page 14

Advanced Insight Scripts (AI-Scripts) 2.5 Release Notes
Table 1: Events Detected by AI-Scripts (continued)
EVENT ID
DFCD_GENCFG_MALLOC_FAILED
DFCD_GENCFG_WRITE_FAILED
DFCD_LINH_MALLOC_FAILED
DFWD_CONFIG_WRITE_FAILED
DFWD_MALLOC_FAILED
DFWD_PARSE_STATE_EMERGENCY
DFWD_TRASHED_RED_ZONE
DH_SVC_RTSOCK_OPEN_FAILURE
DH_SVC_RTSOCK_REGISTER_FAILURE
DH_SVC_SETSOCKOPT_FAILURE
DH_SVC_SOCKET_FAILURE
ESPTASK_PARSE_CMD_ARG
ESPTASK_PARSE_CMD_EXTRA
ESWD_PPM_READ_ERROR
ESWD_PPM_WRITE_ERROR
ESWD_STP_BASE_MAC_ERROR
EVENTD_EVENT_SEND_FAILED
14
DESCRIPTION
The dynamic flow capture process (dfcd) could not allocate memory for the
GENCFG message.
The dynamic flow capture process (dfcd) could not send the GENCFG
message for the indicated reason.
The dynamic flow capture process (dfcd) could not allocate memory for the
LINH message.
The firewall process (dfwd) encountered an error while trying to send an
interface configuration to the kernel over the routing socket.
The firewall process (dfwd) must dynamically malloc memory for its needs.
This allocation request failed. The specific data structure that was being
allocated is listed in the message.
The firewall process (dfwd) encountered an unhandled internal state while
parsing an interface.
When the firewall process (dfwd) is allocating heap memory, it uses a
private memory allocator that writes a special pattern at the end of each
allocated segment of heap memory. Later, when de-allocating this memory,
dfwd checks for the pattern. Not finding the previously written pattern
means the memory was overwritten, which indicates an error in dfwd.
The Dynamic Host Configuration Protocol (DHCP) services process (dhcp-
service) could not successfully open a routing socket to the kernel. The
error string accompanying this log entry indicates the specific error.
The Dynamic Host Configuration Protocol (DHCP) services process (dhcp-
service) could not successfully register a callback function with a routing
socket. The error string accompanying this log entry indicates the specific
error.
The Dynamic Host Configuration Protocol (DHCP) services process (dhcp-
service) could not set the indicated socket option.
The Dynamic Host Configuration Protocol (DHCP) services process (dhcp-
service) could not create a socket.
This process terminated because of an internal error.
This process terminated because of an invalid option.
The ethernet bridging process (eswd) could not read a message available
on the read pipe from the periodic packet management process (ppmd).
The ethernet bridging process (eswd) could not write a message on the pipe
to the periodic packet management process (ppmd).
This condition occurs when STP cannot derive the base MAC address of
the system.
Junos processes can request that the event processing process (eventd)
notify them when a specific event occurs. eventd could not send an event
notification for the indicated reason.
©
Copyright 2010, Juniper Networks, Inc.