Table of Contents
Advertisement
Grounding instructions (e ectr c gn tion mode s on y)
iMPORTANT: READ AND SAVE THESE iNSTRUCTiONS.
This appliance is equipped with a 3-prong grounding plug
for your protection against shock hazard and should be plugged directly
into a properly grounded receptacle. DO NOT cut or remove the grounding
prong from this plug.
For personal safety, this oven must be properly grounded. For maximum
safety, the power cord must be plugged into a 120V--60
Hz. outlet that is
correctly polarized and properly grounded.
If a two-prong wall receptacle is the only available outlet, it is the personal
responsibility of the consumer to have it replaced with a properly grounded
three-prong wall receptacle installed by a qualified electrician.
Do not under any circumstances
cut or remove the third round
grounding prong from the power cord plug. See the installation instructions
packaged with this oven for complete installation and grounding
instructions. Do not operate the oven using a two-prong adapter or an
extension cord.
Avoid
fire
hazard
or
electrical shock. Do not use an adaptor
plug,
an extension
cord,
or remove
grounding prong from electrical power cord.
Failure to follow this warning can cause
serious injury, fire or death.
Grounding
type wall
receptacle
-x
Do not, under any
circumstances,
cut, I
remove, or bypass|
the grounding pron_)
Power supply cord with
3-prong grounding plug
Oven ignition
When you turn the oven on, the glow bar igniter begins to heat. When the lighter is hot enough, in less than 1
minute, the gas flows into the burner and is ignited.
The igniter glows bright orange when hot. It cycles on and off with the thermostat and will glow whenever the burner
is on.
Do not attempt to light the oven burners
during a power failure. The oven burner valves will not
open up and will prevent the gas from flowing through the burner valves to the burners. In the event of a power
failure, turn the Temperature Control knob to OFF. When power resumes, turn the Temperature Control knob back to
desired temperature.
_ii:iJ::iii_
..........
ilii .......
Conversion
to Liquefied Petroleum Gas (or L. P. Gas)
This natural gas range is designed to allow for conversion to Liquefied Petroleum (L. P.) Gas.
Only a qualified service agent should perform the L. P. conversion. Contact the local gas provider for conversion. An L.
P. Conversion Kit is supplied with this range and is located on the main back of the range. The kit contains installation
instructions which must be read before and followed carefully when installing the kit.
To avoid serious injury, any additions, changes or conversions required in order for this appliance to
satisfactorily meet the application needs must be made by a qualified service agent.
Advertisement
Table of Contents
