General Care & Cleaning
To Remove and Replace
To Remove the Oven Bottom:
Lift up the lift tab at the back of the oven bottom
Slide oven bottom out, and lift it up and out.
To Replace the Oven Bottom:
Slide horizontal tabs on back of oven bottom into the holes at the back of
Lower the front of the oven bottom so locking flange fits into locking channel•
Replace lift tab to hold oven bottom in place•
The drawer can be removed to facilitate cleaning under the wall oven. Use care when
handling the drawer.
To Remove the Storage Drawer
1. Open and empty the drawer of all utensils.
2. Pull drawer out until it stops.
3. Lift the drawer to allow the drawer rollers to clear the first guide stopper (not
4. Pull the drawer out unitl it stops again.
5. Tilt the drawer down to allow the drawer rollers to clear the frame rollers.
To Replace the Storage Drawer
1. Insert the rear end of the drawer into the opening.
2. Tilt the drawer down and fit the drawer rollers behind the frame rollers.
D rawe r
Push the drawer in until it stops, then lift the drawer to allow the drawer rollers to clear the guide stoppers (not visible)
Close the drawer.
Flammable materials should not be stored in an oven or in the storage or broiler drawer. This includes paper,
plastic and cloth items, such as cookbooks, plasticware and towels, as well as flammable liquids. Do not store explosive
containers, such as aerosol cans, on or near the appliance. Flammable materials may explode and result in fire or property
Adjusting the Oven Temperature
Your oven control has been precisely set at the factory. This setting may differ from your previous oven however, so your
recipe times may not give you the results you expect. If you think that the oven is cooking too hot or too cool for your recipe
times, you can adjust the control so that the oven cooks hotter or cooler than the temperature displayed.
To Adjust Oven Temperature:
Set the temperature to 550°F (287°C) by pressing and holding the A.
Within 2 seconds, pressandhold_untilthe2digitdisplayappears.
Release #_. The display now indicates the amount
of degrees offset between the original factorytemperature
setting and the current temperature setting. If the oven control
has the original factory calibration, the display will read "0."
The temperature can now be adjusted up or down 35°F (17°C), in 5°F steps by pressing and holding the /_. or V.
Adjust until the desired amount of offset appears in the display. When lowering the oven temperature, a minus sign (-
) will appear before the number to indicate that the oven will be cooler by the displayed amount of degrees.
When you have made the desired adjustment, press
..... to go back to the time of day display.
Note: Oven temperature adjustments made will not change the Self-Cleaning feature temperature.