Cisco IDS 4210 - Intrusion Detection Sys 4210 Sensor Installation Manual page 10

Installing the Accessories
Lift IDS-4210 into position between the two posts with the hole in the mounting bracket aligned one hole
Step 6
above the mark you made in the two posts (see
Step 7 Secure IDS-4210 to the rack using a screw through the mounting bracket to the front of the left and right
posts (see
Installing Front Mount Brackets
Make sure you have the following supplies (found in the front mount bracket assembly kit) and tools to
install the front mount brackets in a two-post, open-frame relay rack:
•
•
•
•
The front mount bracket assembly is not intended for use as a slide rail system. The server must be firmly
Note
attached to the rack, as shown in
Figure 2-4
Phillips screws
Installing Cisco Intrusion Prevention System Appliances and Modules 5.1
2-10
Figure 2-3 on page 2-9).
Two chassis support brackets
Two rack-mounting brackets
Six screws
#2 Phillips screwdriver
Front Mount Brackets
Pan-head
LINK
CON S
ETH ERN ET
Figure 2-3 on page
Figure 2-4.
100M bps
LINK 100M
bps
DRIV E 0
DRIV E 1
0 ETH ERN
ET 1
SCS I LVD ONLY
DRIV E 0
DRIV E 1
Chapter 2 Installing IDS-4210
2-9).
Pan-head
Phillips screws
(to rack)
OL-8677-01