Installing Center Mount Brackets - Cisco IDS 4210 - Intrusion Detection Sys 4210 Sensor Installation Manual

Installing the Accessories
To insert the bezel on IDS-4210, follow these steps:
Step 1
a.
b.
c.
To remove the bezel from IDS-4210, press the side tabs and pull.
Step 2

Installing Center Mount Brackets

You need the following tools and supplies to install the brackets in a two-post, open-frame relay rack:
•
•
To install the center mount brackets in a two-post, open-frame relay rack, follow these steps:
Determine where you want to place IDS-4210.
Step 1
Mark the upper and lower mounting positions on the two posts.
Step 2
Installing Cisco Intrusion Prevention System Appliances and Modules 5.1
2-8
Align the bottom tabs on the bezel with the slots on IDS-4210.
Align the side tabs on the bezel with the slots on IDS-4210.
Press the bezel into IDS-4210.
#2 Phillips screwdriver
Masking tape or felt-tip pen to mark the mounting holes to be used
Chapter 2 Installing IDS-4210
OL-8677-01