NETGEAR GS724TS - ProSafe 24 Port Gigabit Stackable Smart Switch Software Administration Manual page 159

GS700TS Smart Switch Software Administration Manual
• Queue – Select the traffic-forwarding queue to which the DSCP is mapped. Four traffic
priority queues are supported (Lowest, Low, Normal and High). The High Queue is
reserved for special traffic and is not recommended for use.
Restore Default Mapping
• Restore Defaults – Restore the DSCP Mapping device factory default values. The
possible field values are:
– Checked – Restores the factory default settings for DSCP mapping values.
– Unchecked – Maintains the current DSCP mapping settings.
2. Select the Queue values for each DSCP In value in the provided fields.
3. Check or uncheck the Restore Defaults box in the provided field.
4. Click APPLY to update the device.
Creating Class Mapping
One IP ACL and/or one MAC ACL comprise a class map. Class maps are configured to match
packet criteria, and are matched to packets on a first-fit basis. For example, Class Map A is
assigned packets based only on an IP based ACL or a MAC-based ACL. Class Map B is assigned
to packets based on both an IP-based and a MAC based ACL.
To define class maps:
1. Click QoS > CoS > Advanced > Class Mapping. The Class Mapping screen displays:
Figure 5-7
The Class Map screen contains the following fields:
• Class-Map Name – Displays the user-defined name of the class map.
Configuring QoS
v1.0, June 2009
5-10