If you are starting with an "out-of-the-box" switch and are not using the Smart Wizard Discovery
utility, you must initially configure your host PC to be on a network segment to match the default
settings of the switch, which are as follows:
•
IP address: 192.168.0.239
•
Subnet mask: 255.255.255.0
Later, you might want to change the network settings to match those of your network (this
procedure is described in
then also be set back to match your network.
Clicking Web Access on the Smart Wizard Discovery utility or accessing the switch directly
displays the following screen.
.
Figure 1-5
Use this screen to proceed to management of the switch, as covered in
the Web Browser
Interface."
Additional Utilities
Alternatively, from the main screen shown in
functions as described in the following sections:
•
"Password
Change"
•
"Firmware
Upgrade"
Getting Started with Switch Management
GS108T Smart Switch Software Administration Manual
"IP Configuration" on page
Figure 1-1 on page 1-3
v1.0, December 2007
3-3). Your host PC network settings must
Chapter 2, "Introduction to
you can access additional
1-7