Kurzweil K2600 - MUSICIANS GUIDE REV A PART NUMBER 910331 CHAP 10 Manual page 17

Inj Build
Inj Spread
Inj LP
Inj Skew
E DiffAmt
E DfLenScl
E Dly Scl
E Build
E Fdbk Amt
E HF Damp
E PreDlyL, E PreDlyR
E Dly L, E Dly R
E Dly LX, E Dly RX
E DifDlyL, E DifDlyR
E DifDlyLX, E DifDlyRX Adjusts the diffusion delays of the diffusers on delay taps fed to the opposite
E X Blend
modeling real spaces. High depth settings can create chorusing qualities, which
wonÕt be unsuitable for real acoustic spaces, but can nonetheless create
interesting effects. Instruments that have little if no inherent pitch ßuctuation
(like piano) are much more sensitive to this LFO than instruments that normally
have a lot of vibrato (like voice) or non-pitched instruments (like snare drum).
Used in conjunction with Inj Spread, this adjusts the envelope of the onset of the
reverb. SpeciÞcally, it tapers the amplitudes of a series of delayed signals
injected into the body of the reverb. Values above 0% will produce a faster
build, while values below 0% will cause the build to be more gradual.
Used in conjunction with Inj Build, this scales the length of the series of delays
injected into the body of the reverb. For a true representation of the selected
Room Type injector spread, set this to 1.00x.
This adjusts the cutoff frequency of a 1 pole (6dB/oct) lopass Þlter applied to
the signal being injected into the body of the reverb.
Adjusts the amount of delay applied to either the left or right channel of the
reverb injector. Positive values delay the right channel while negative values
delay the left channel.
Adjusts the amount of diffusion applied to the early reßection network.
Adjusts the length of diffusion applied to the early reßection network. This is
inßuenced by E PreDlyL and E PreDlyR.
Scales the delay lengths inherent in the early reßection network.
Adjusts the envelope of the onset of the early reßections. Values above 0% will
create a faster attack while values below 0% will create a slower attack.
Adjusts the amount of the output of an early reßection portion that is fed back
into the input of the opposite channel in front of the early pre-delays. Overall, it
lengthens the decay rate of the early reßection network. Negative values
polarity invert the feedback signal.
This adjusts the cutoff frequency of a 1 pole (6dB/oct) lopass Þlter applied to
the early reßection feedback signal.
Adjusts how much the early reßections are delayed relative to the dry signal.
These are independent of the late reverb predelay times, but will inßuence E
Dly Scl.
Adjusts the left and right early reßection delays fed to the same output
channels.
Adjusts the left and right early reßection delays fed to the opposite output
channels.
Adjusts the diffusion delays of the diffusers on delay taps fed to the same
output channels.
output channels.
Adjusts the balance between early reßection delay tap signals with diffusers fed
to their same output channel, and those fed to opposite channels. 0% will only
allow delay taps being fed to opposite output channels to be heard, while 100%
allows only delay taps going to the same channels to be heard.
KDFX Reference
KDFX Algorithm Specifications
10-17