Kurzweil K2600 - MUSICIANS GUIDE REV A PART NUMBER 910331 CHAP 10 Manual page 164

KDFX Reference
KDFX Algorithm Specifications
Page 2
Lo Enable
Lo Drive
Lo Xfer
Lo Delay
Lo Mix
Page 3
Hi Enable
Hi Drive
Hi Xfer1
Hi Xfer2
Hi Delay
Hi Mix
In/Out
Out Gain
CrossOver1
CrossOver2
Enable
Drive
Xfer
Delay
Mix
10-164
On or Off
Off, -79.0 to 24.0 dB
-100 to 100%
0 to 1000 samp
Off, -79.0 to 24.0 dB
On or Off
Off, -79.0 to 24.0 dB
-100 to 100%
-100 to 100%
0 to 500 samp
Off, -79.0 to 24.0 dB
When set to ÒInÓ the effect is active; when set to ÒOutÓ the effect is bypassed.
The overall gain or amplitude at the output of the effect.
Adjusts one of the -6dB crossover points at which the input signal will be divided into the
high, mid and low bands.
Adjusts the other -6dB crossover points at which the input signal will be divided into the
high, mid and low bands.
Low, Mid, and High. Turns processing for each band on or off. Turning each of the 3 bands
off results in a dry output signal.
Low. Mid, and High. Adjusts the input into each transfer. Increasing the drive will
increase the effects.
Low, Mid, and High; Xfer1 and Xfer2 for Mid and High. Adjusts the intensity of the
transfer curves.
Low, Mid, and High. Adjusts the number of samples the each signal is delayed.
Low, Mid, and High. Adjusts the output gain of each band.
Mid Enable On or Off
Mid Drive Off, -79.0 to 24.0 dB
Mid Xfer1 -100 to 100%
Mid Xfer2 -100 to 100%
Mid Delay 0 to 500 samp
Mid Mix Off, -79.0 to 24.0 dB