Kurzweil K2600 - MUSICIANS GUIDE REV A PART NUMBER 910331 CHAP 10 Manual page 137

The output from LaserVerb can be fed back to the input. By turning up the feedback, the duration of the
LaserVerb sound can be greatly extended. Cross-coupling may also be used to move the signal between
left and right channels, producing a left/right ping-pong effect at the most extreme settings.
The 2 processing allocation unit (PAU) version is a sparser version than the 3 PAU version. ItÕs buzzing is
somewhat coarser. The 1 PAU version is like the 2 PAU version except the two input channels are summed
and run through a single mono LaserVerb. The 1 PAU version does not have the cross-coupling control but
does have output panning.
L Input
Figure 10-74 LaserVerb
Parameters for LaserVerb and LaserVerb Lite
Wet/Dry
Fdbk Lvl
Xcouple
HF Damping
Parameters for Mono LaserVerb
Page 1
Wet/Dry
Fdbk Lvl
HF Damping
Page 2
Dly Coarse
Dly Fine
Spacing
Wet/Dry The amount of reverbed (wet) signal relative to unaffected (dry) signal.
Feedback
From Right To Right
Channel Channel
0 to 100%wet
0 to 100%
0 to 100%
16 to 25088Hz
0 to 100%wet
0 to 100%
16 to 25088Hz
0 to 5000ms
-20.0 to 20.0ms
0.0 to 40.0samp
Dry
LaserVerb
Out Gain Off, -79.0 to 24.0dB
Out Gain Off, -79.0 to 24.0dB
Pan -100 to 100%
Contour 0.0 to 100.0%
KDFX Reference
KDFX Algorithm Specifications
Wet
L Output
10-137