Kurzweil K2600 - MUSICIANS GUIDE REV A PART NUMBER 910331 CHAP 10 Manual page 135

910 3 Band Shaper
3 band shaper
PAUs: 2
The 3 Band Shaper non-destructively splits the input signal into 3 separate bands using 1 pole (6dB/oct)
Þlters, and applies a VAST-type shaper to each band separately. Refer to the Musicians Guide for an
overview of VAST shaping. The cutoff frequencies for these Þlters are controlled with the CrossOver1 and
CrossOver2 parameters. The low band contains frequencies from 0 Hz (dc) to the lower of the 2 CrossOver
settings. The mid band contains frequencies between the 2 selected frequencies, and the hi band contains
those from the higher of the 2 CrossOver settings all the way up to 24kHz.
Each frequency band has an enable switch for instantly bypassing any processing for that band , and a Mix
control for adjusting the level of each band that is mixed at the output. negative Mix values polarity invert
that band. The shaper Amt controls provide the same type of shaping as VAST shapers, but can go to 6.00x.
Parameters
Page 1
Wet/Dry -100 to 100%
CrossOver1 17 to 25088 Hz
CrossOver2 17 to 25088 Hz
Page 2
Lo Enable On or Off
Lo Amt 0.10 to 6.00x
Lo Mix -100 to 100%
Mid Enable On or Off
Mid Amt 0.10 to 6.00x
Mid Mix -100 to 100%
In/Out When set to ÒInÓ the effect is active; when set to ÒOutÓ the effect is bypassed.
Out Gain The overall gain or amplitude at the output of the effect.
CrossOver1 Adjusts one of the -6dB crossover points at which the input signal will be divided into the
high, mid and low bands.
CrossOver2 Adjusts the other -6dB crossover points at which the input signal will be divided into the
high, mid and low bands.
Enable Low, Mid, and High. Turns processing for each band on or off. Turning each of the 3 bands
Off results in a dry output signal.
Amt Low, Mid, and High. Adjusts the shaper intensity for each band.
Mix Low, Mid, and High. Adjusts the level that each band is summed together as the wet
signal. Negative values polarity invert the particular bands signal.
Out Gain Off, -79.0 to 24.0 dB
Lo Enable On or Off
Lo Amt 0.10 to 6.00x
Lo Mix -100 to 100%
KDFX Reference
KDFX Algorithm Specifications
10-135