3.SETTING NETWORK FUNCTIONS (Cont.)
5
Specify the following items as required.
• DHCP (IP Address)—Select whether or not the IPv6 address which is issued from the DHCPv6 server is used
for this equipment. Press the [ENABLE] button to use the address, or [DISABLE] button to not use it.
• DHCP (OPTIONS)—Select whether or not the optional information (IPv6 address for the DNS server, etc.)
4
except the IPv6 address for this equipment, which is issued from the DHCPv6 server is used on this equip-
ment. Press the [ENABLE] button to use the information, or [DISABLE] button to not use it.
• In "AUTO" mode, you cannot assign "IP ADDRESS", "PREFIX" and "GATEWAY" manually.
• Either "DHCP (IP Address)" or "DHCP (OPTIONS)" must be in "ENABLE" mode.
6
Press the [ENTER] button.
• Returns you to the NETWORK menu.
7
Continue to another network setting if required, then press the
[APPLY NOW] button.
• The "NETWORK INITIALIZING" message is displayed and this equipment starts initializing the network inter-
face card to apply the changes.
If Duplicate Address Detection (DAD) detects duplicate addresses, the message "IPv6 ADDRESS CONFLICT" is
displayed on the touch panel.
150
4.SETTING ITEMS (ADMIN)