Cli Examples - Dell PowerConnect M6220 Configuration Manual

• To prevent any RIP packets from being received
• To prevent any RIP packets from being transmitted

CLI Examples

The configuration commands used in the following example enable RIP on ports vlan 2 and vlan 3 as
shown in the network illustrated in Figure 4-6.
Figure 4-6. Port Routing Example Network Diagram
Example #1: Enable Routing for the Switch
The following sequence enables routing for the switch:
console#config
ip routing
exit
Example #2: Enable Routing for Ports
The following command sequence enables routing and assigns IP addresses for ports vlan 2 and vlan 3.
console#config
interface vlan 2
routing
ip address 192.150.2.2 255.255.255.0
exit
78
Routing Configuration
VLAN 3
192.130.3.1
192.130.3.1
Layer 3 Switch
acting as a router
VLAN 2
Port 1/0/2
192.150.2.2
192.150.2.2
Subnet 2
Port 1/0/3
VLAN 5
192.64.4.1
Port 1/0/5
192.64.4.1
Subnet 3
Subnet 5