Cli Examples - Dell PowerConnect M6220 Configuration Manual

CLI Examples

The following examples show commands to use with the IGMP Snooping feature.
Example #1: Enable IGMP Snooping on the Switch
NOTE:
Before you enable IGMP Snooping on the switch, you must enable the filtering of multicast addresses with
the bridge multicast filtering command.
console(config)#bridge multicast filtering
console(config)#ip igmp snooping
Example #2: Enable IGMP Snooping on an Interface
console(config)#interface ethernet 1/g1
console(config-if-1/g1)#ip igmp snooping ?
host-time-out
leave-time-out
mrouter-time-out
<cr>
console(config-if-1/g1)#ip igmp snooping
console(config-if-1/g1)#exit
Example #3: Show IGMP Snooping Information for the Switch
console#show ip igmp snooping
Admin Mode..................................... Enable
Multicast Control Frame Count.................. 0
Interfaces Enabled for IGMP Snooping........... 1/g1
Vlans enabled for IGMP snooping................ None
Example #4: Show IGMP Snooping Information for an Interface
console#show ip igmp snooping interface ethernet 1/g1
Slot/Port...................................... 1/g1
Global IGMP Snooping Admin Mode................ Enabled
IGMP Snooping Admin Mode....................... Enabled
Fast Leave Mode................................ Disabled
Group Membership Interval...................... 260
Max Response Time.............................. 10
Multicast Router Present Expiration Time....... 300
Configure host time out parameter.
Configure leave time out parameter.
Configure mrouter time out parameter.
Press enter to execute the command.
Switching Configuration
31